• Complete putty-and-wash system for compatible C-silicone impression techniques.
• Putty provides high viscosity for tray support and preliminary form.
• Light-body component provides flow for recording fine surface detail.
• Thixotropic wash behaviour supports controlled placement around preparations.
• Good tear resistance supports impression removal from detailed areas.
• Compatible activator is included for preparation of the selected system components.
• Suitable for one-stage or two-stage putty-and-wash workflows when used according to the Zhermack IFU.

Polysiloxane (Condensation Silicone)

This soft-to-mix, elastic-setting putty is suitable for a wide range of clinical situations and is particularly recommended for the single-stage impression technique. It offers an excellent balance between rigidity and elasticity, ensuring accurate results with high dimensional stability.

Applications:• Zetaplus: Polysiloxane designed for the first impression, featuring high initial flow during the working phase and excellent rigidity after setting. Recommended for the two-stage (double) impression technique.
• Zetaplus Soft: Polysiloxane with good initial flow and sufficient elasticity for easy removal from the oral cavity. Also recommended for the two-stage technique.
• Oranwash VL: Low-viscosity, highly fluid, hydro-compatible polysiloxane. Ideal for the two-stage impression technique.
• Oranwash L: Low-viscosity, extremely fluid, hydro-compatible polysiloxane suitable for two-stage impressions.
• Thixoflex M: Low-viscosity, thixotropic, hydro-compatible polysiloxane. It stays in place when injected directly onto the preparation but flows easily where needed. Recommended for two-stage, single-phase impressions, and for relining removable prostheses.
Key Features:• Excellent balance between rigidity and elasticity
• Ideal working and setting time ratio
• High flowability and accuracy of wash materials
• Putty and wash materials activated with the same catalyst

Technical Specifications

• Setting Type: Normal set
• Working Time: 1 minute 15 seconds
• Intraoral Time: 3 minutes 15 seconds
• Total Setting Time: 4 minutes 30 seconds
• ISO 4823 Classification: Type 0, Putty Consistency
• Strain in Compression: 2–5%
• Elastic Recovery: Greater than 98%
• Linear Dimensional Change (after 24 hours): Less than 0.2%

• 1 900 ml tub (1.53 kg)
• 1 x 140 ml Oranwash VL
• 1 x 60 ml Indurent Gel
• 1 x Mixing Pad (15 Sheets)
• 1 x Measuring Spoon

1. Select a rigid impression tray and apply the compatible tray adhesive where required.
2. Measure or dispense the selected Zhermack C-silicone base material and the correct amount of compatible Indurent catalyst according to the product IFU.
3. Mix thoroughly by hand or on a clean mixing pad until a uniform, streak-free colour is obtained.
4. Load the tray or apply the wash material using the selected one-stage or two-stage impression technique.
5. Seat the tray promptly and keep it stable until the material has completely set.
6. Remove the impression carefully, inspect the reproduced detail and trim excess material where appropriate.
7. Rinse and disinfect the impression using a compatible protocol before casting or laboratory processing.

Manufactured by: Zhermack S.p.A., Italy

Not Applicable