• Gel catalyst for compatible Zhermack clinical C-silicone impression materials.
• Red colour provides visual control of mixing homogeneity.
• Compatible with Zetaplus putty and corresponding Oranwash materials.
• Tube format supports controlled dispensing on a mixing pad or into hand-mixed putty.
• One catalyst can be used across the compatible Zetaplus clinical C-silicone system.
• Designed to produce a uniform set when the prescribed catalyst ratio is followed.

Zhermack Zetaplus Indurent Catalyst Gel for C-Silicone impression materials is specifically formulated for clinical and intraoral applications. It is biocompatible, even on compromised mucosa, ensuring safe use in a variety of patient situations. The optimized catalyst dosage extends working time while minimizing contraction, maintaining an ideal balance between working and setting times for precise impressions.

The red-colored gel catalyst in the Zhermack Zetaplus system guarantees homogeneous mixing control, making it a key component for achieving consistent and reliable results. Its versatile formulation allows for easy dispensing on a mixing pad, enhancing workflow efficiency and improving the overall effectiveness of clinical procedures with C-Silicones.

Designed for user-friendly application, this catalyst gel provides dental professionals with precision, convenience, and confidence in their impressions.

Compatible with the following products:• Zetalabor Putty
• Thixoflex M
• Oranwash L
• Oranwash VL
• Zetaplus Soft

• Material: C - silicone
• Color: Red
• Type: Catalyst gel
• Type of setting (with base):  Normal Set
• Working time (with base): 1min. 15 sec.
• Time in mouth(with base): 3 min. 15 sec.
• Setting time(with base): 4 min. 30sec.

• 1 Tube x 60ml

1. Select a rigid impression tray and apply the compatible tray adhesive where required.
2. Measure or dispense the selected Zhermack C-silicone base material and the correct amount of compatible Indurent catalyst according to the product IFU.
3. Mix thoroughly by hand or on a clean mixing pad until a uniform, streak-free colour is obtained.
4. Load the tray or apply the wash material using the selected one-stage or two-stage impression technique.
5. Seat the tray promptly and keep it stable until the material has completely set.
6. Remove the impression carefully, inspect the reproduced detail and trim excess material where appropriate.
7. Rinse and disinfect the impression using a compatible protocol before casting or laboratory processing.

Manufactured by: Zhermack S.p.A., Italy

Not Applicable