• Minimizes mucosal compression during oral cavity insertion
• Achieves excellent hardness after setting
• Functions effectively as a special tray in the two-stage technique
• Adapts perfectly to low-viscosity material in double-mixing applications
• Offers adjustable working and setting times depending on catalyst amount (Indurent Gel)
• Compatible with safe disinfection using Zeta 7 Solution and Zeta 7 Spray

Zetaplus by Zhermack is a condensation silicone elastomeric impression material designed for final impressions of extraorally fabricated prostheses. With over 25 years of consistent performance, Zetaplus has earned wide acceptance among dental professionals for its reliability and precision. This hydro-compatible material is specifically formulated for high-accuracy impressions, combining excellent flow during the working phase with strong rigidity after setting. It is supplied in a green color with a spearmint flavor for patient comfort.

Primarily used in the two-stage impression technique, Zetaplus can also be applied in a single-stage procedure using its two viscosities. By optimizing the catalyst dosage, the working time can be extended while minimizing contraction, achieving a balanced workflow between working and setting times. The inclusion of high-activity spheroid filler Synthetic Amorphous Silica (SAS) enhances both flowability and dimensional stability, ensuring precise and reliable results.

Characteristics• High initial flowability and excellent rigidity after setting for putty materials
• Thixotropic behavior for wash materials
• High tear resistance
Advantages• Optimal balance between rigidity and elasticity
• Ideal ratio of working time to setting time
• Superior flow and accuracy of wash materials
• Compatibility of putty and wash materials using the same catalyst (Indurent Gel)

• Clinical working time* (min:s) - 1:15
• Setting time(min:s) - 4:45
• Time in mouth* (min:s) - 3:30

• 1 x 10kg Bucket

1. Select a rigid impression tray and apply the compatible tray adhesive where required.
2. Measure or dispense the selected Zhermack C-silicone base material and the correct amount of compatible Indurent catalyst according to the product IFU.
3. Mix thoroughly by hand or on a clean mixing pad until a uniform, streak-free colour is obtained.
4. Load the tray or apply the wash material using the selected one-stage or two-stage impression technique.
5. Seat the tray promptly and keep it stable until the material has completely set.
6. Remove the impression carefully, inspect the reproduced detail and trim excess material where appropriate.
7. Rinse and disinfect the impression using a compatible protocol before casting or laboratory processing.

Manufactured by: Zhermack S.p.A., Italy

Not Applicable