• Low-viscosity wash material supports reproduction of fine surface detail.
• Flow characteristics help the material adapt around prepared teeth and margins.
• Suitable for use with compatible Zetaplus putty in one-stage or two-stage techniques.
• Compatible with Indurent gel catalyst in the Zhermack C-silicone system.
• Controlled consistency helps minimise unnecessary compression during placement.
• Working and setting behaviour can be managed by following the prescribed catalyst quantity and temperature conditions.

Low-Viscosity C-Silicone

Suitable for both the two-stage technique and the single-stage technique using two viscosities.

Advantages• Flowable consistency for easy handling
• Excellent penetration into the gingival sulcus
• Compatible with safe disinfection using Zeta 7 Solution and Zeta 7 Spray
• Quick and bubble-free mixing with Alghamix II
Characteristics• Hydrophilic nature for improved moisture tolerance
• Yellow color
• Orange flavor

• Clinical working time* (min:s) - 1:30
• Time in mouth* (min:s) - 3:30
• Setting time(min:s) - 5:00
• Scent - orange
• Elastic recovery - 98,5 %

• 1 x 140ml Tube 

1. Select a rigid impression tray and apply the compatible tray adhesive where required.
2. Measure or dispense the selected Zhermack C-silicone base material and the correct amount of compatible Indurent catalyst according to the product IFU.
3. Mix thoroughly by hand or on a clean mixing pad until a uniform, streak-free colour is obtained.
4. Load the tray or apply the wash material using the selected one-stage or two-stage impression technique.
5. Seat the tray promptly and keep it stable until the material has completely set.
6. Remove the impression carefully, inspect the reproduced detail and trim excess material where appropriate.
7. Rinse and disinfect the impression using a compatible protocol before casting or laboratory processing.

Manufactured by: Zhermack S.p.A., Italy

Not Applicable