• Biocompatible
• Simplified mixing and balanced thixotropy for easier model production
• High compressive strength
• Reduced abrasion for higher model precision
• Silver-grey color optimized for modern laser and optical scanner detection
• Low expansion maintained even after 48 hours

Zhermack Elite Rock (C410010) is a Type IV extra-hard dental die stone designed for producing highly accurate master models in fixed prosthodontics. Its silver-grey shade is optimized for laser and optical scanner detection, making it particularly effective for CAD/CAM workflows.

The material provides outstanding compressive strength, resulting in reduced abrasion and improved precision during model fabrication. Its balanced thixotropy ensures smooth, simplified mixing and supports consistent, reliable model production.

Elite Rock also features very low setting expansion, maintaining dimensional stability for up to 48 hours—an essential factor for ensuring the accuracy of final prostheses. These combined characteristics make it a strong choice for creating durable, precise models and removable dies in both fixed and removable prosthodontic applications.

• Water/Powder Ratio: 20ml/100g
• MixingTime (manual): 0:30 sec
• Mixing Time (vacuum): 0:30 sec
• Working Time: 12:00 min
• Setting Time (VICAT): 14:00 min
• Removal Time: 45:00 min
• Setting Expansion 2 Hours: 0.08%
• Setting Expansion 48 Hours: 0.19%
• Compressive Strenght 1 Hour: 52 MPa (530 kg/cm²)
• Compressive Strenght 48 Hours: 81 MPa (826 kg/cm²)

• 3 kg pack

1. Use a clean, dry mixing bowl and verify the powder and liquid are within their labelled shelf life.

2. Measure water and Elite Rock powder using the ratio specified in the current Zhermack instructions for use.

3. Add powder to water and mix until a smooth, homogeneous stone mix is obtained, using vacuum mixing where indicated.

4. Introduce the stone into the cleaned impression in small increments while using gentle vibration to reduce trapped air.

5. Complete the pour without over-vibrating the material and allow the cast to set undisturbed for the stated time.

6. Separate the model from the impression only after adequate hardening.

7. Trim and finish the cast as required and allow it to reach sufficient strength before laboratory processing.

Manufactured by: Zhermack S.p.A., Italy

Not Applicable