• Features a low-viscosity formulation that flows effortlessly into intricate preparations and minimal access cavities.
• Formulated with UDMA resin matrix to significantly reduce polymerization shrinkage and minimize postoperative sensitivity.
• Releases fluoride continuously into surrounding tissues to aid remineralization and suppress secondary caries development.
• Contains nano-sized filler particles that enhance polishability, surface luster, and resistance to physical wear.
• Engineered with natural fluorescence properties to match surrounding tooth structure seamlessly under UV lighting conditions.
• Displays distinct radiopacity for effortless radiographic evaluation of restoration margins over time.
• Supplied with a 12.2 mm tip that provides extended reach and direct placement into narrow or deep preparations.

SDI Wave Flowable Composite A1 is a versatile, light-curing nano-hybrid restorative material designed for a wide spectrum of direct dental procedures. Its lower viscosity properties allow the resin to adapt smoothly to cavity walls, filling micro-voids without slumping or trapping air. The inclusion of a UDMA resin base limits volumetric shrinkage during light curing, effectively protecting the pulp-dentin complex from thermal stress and marginal leakage. This 1 g refill syringe in shade A1 is ideal for restoring lighter enamel tones, Class V cervical lesions, minimally invasive Class I through IV preparations, and sealing pits or fissures. Additionally, continuous fluoride ion movement provides ongoing protection against marginal decay, making it a reliable solution for preventive and restorative therapy.

• Product type: Light-cured flowable nano-hybrid restorative composite
• Shade: A1
• Pack size: 1 g syringe
• Filler: Specially treated nano-fillers
• Resin system: UDMA-based
• Properties: Fluoride releasing, radiopaque and naturally fluorescent
• Placement: Incremental light-curing technique

1 Pack Contains:
• 1 × Syringe – 1 g
• 5 × Single-Use Disposable Tips (20 Gauge)

1. Clean and isolate the target tooth surface thoroughly using a rubber dam or preferred isolation technique. Select shade A1 under natural lighting while the tooth surface remains clean and moist.
2. Prepare the conservative cavity, apply a pulp protection liner if deep, and etch enamel and dentin according to total-etch protocol.
3. Apply a compatible dental adhesive, gently air-dry to evaporate the solvent, and light-cure per adhesive instructions.
4. Attach the single-use dispensing tip securely to the syringe and directly inject the material in increments of 2 mm or less.
5. Light cure each 2 mm layer for 20 seconds using a curing light operating between 440–480 nm wavelength.
6. Polish and finish the restoration using standard composite finishing points and polishing strips.

Manufactured by: SDI Limited, Australia

Not Applicable