* Forms a protective barrier over dentinal tubules to minimize fluid microleakage
* Contains active sodium fluoride to assist in alleviating thermal sensitivity
* High fluidity enables effortless and smooth application across intricate cavity preparation walls
* Supplied ready-to-use without requiring external thinners or solvent adjustments
* Acts as an effective insulating protective layer prior to placing amalgam, cement, or restorative materials
* Evaporates rapidly upon air contact to form a uniform protective film

Prevest Copal F is a copal gum-based protective cavity varnish enriched with sodium fluoride, engineered to seal exposed dentinal tubules and protect tooth structures from thermal shocks. By creating an insulating layer over cut dentin surfaces, it effectively reduces fluid penetration into the pulp chamber, minimizing post-restorative sensitivity.
This varnish is indicated for use as an intermediary liner before placing amalgam restorations, indirect cements, or composite materials. Its low-viscosity formulation allows seamless spreading, drying rapidly within 40 seconds to form a smooth protective film without altering cavity dimensions.
Supplied in a 15 ml glass bottle complete with a dispensing dropper, Prevest Copal F offers a ready-to-use solution that requires no thinners. It provides consistent intraoperative convenience while protecting the pulp-dentin complex during routine restorative procedures.

* Composition: Copal Gum, Isopropyl Alcohol, and 0.2% Sodium Fluoride (900 ppm fluoride)
* Product Form: Liquid varnish
* Volume: 15 ml
* Curing Type: Air drying
* Radiopacity: Not specified
* Sterility: Non-sterile
* Shelf Life: 3 years from manufacturing date
* Storage Conditions: Store between 10°C and 24°C in a dry place with cap tightly secured

1 Pack Contains:
* 1 × 15 ml Glass Bottle
* 1 × Dispensing Dropper
* 1 × Instruction Manual

1. Prepare and clean the cavity preparation according to standard clinical procedure.
2. Dispense a small volume of varnish using the provided dropper onto a fresh cotton pellet or microbrush.
3. Apply an even, thin coating across the interior walls of the prepared cavity.
4. Allow the applied layer to air dry for approximately 40 seconds.
5. Apply a second thin layer using a new application tool if additional sealing is necessary.
6. Close the bottle cap tightly immediately after dispensing to prevent solvent evaporation.

Manufactured by: Prevest Denpro Limited, India

Not Applicable