* One-bottle primer and adhesive simplifies the conventional etch-and-rinse bonding sequence.
* Designed for reliable adhesion to prepared enamel and dentin.
* Light-cured formulation integrates with common direct restorative workflows.
* Low-volume 4 ml refill is practical for routine chairside use.
* Compatible with phosphoric-acid etching as part of the total-etch technique.
* Supports marginal sealing when applied according to the bonding protocol.
* Suitable for use with compatible light-cured restorative materials.

Kulzer Gluma Bond5 4ml is a fifth-generation, light-cured one-bottle adhesive designed for the conventional etch-and-rinse bonding technique.

It is used to bond compatible direct restorative materials to enamel and dentin during routine adhesive restorative procedures.

The listed refill contains one 4 ml bottle and should not be confused with GLUMA Bond Universal, which uses different bonding protocols.

* Product Type: Dental adhesive
* Generation: Fifth-generation bonding system
* Technique: Etch-and-rinse
* Configuration: One-bottle primer and adhesive
* Curing Type: Light-cured
* Bottle Content: 4 ml
* Substrates: Enamel and dentin

1 Pack Contains:
* 1 × GLUMA Bond5 Bottle – 4 ml

1. Isolate the tooth and clean the prepared enamel and dentin surfaces.
2. Etch the required tooth surfaces with a compatible phosphoric-acid etchant according to its instructions.
3. Rinse the etchant thoroughly and remove excess moisture without over-drying dentin.
4. Dispense GLUMA Bond5 and apply it evenly to the prepared surfaces.
5. Gently air-thin the adhesive to create a uniform film and evaporate solvent.
6. Light-cure the adhesive according to the product instructions and curing-light output.
7. Proceed with placement and curing of the selected compatible restorative material.

Manufactured by: Kulzer GmbH, Germany

Not Applicable