* Variable-time impression concept provides flexibility during clinical handling.
* Putty and light-body combination supports two-viscosity precision impressions.
* Low-viscosity Light Flow adapts closely around prepared margins and fine details.
* Easy Putty provides a stable tray material for the wash impression.
* VPS chemistry offers elastic recovery suitable for precision impression procedures.
* Automix Light Flow cartridges support clean and consistent wash-material dispensing.

Heraeus Kulzer Variotime Easy Putty & Light Flow is a VPS precision impression combination that pairs a stable hand-mixed putty with a low-viscosity wash material.

It is suitable for precision prosthodontic impressions such as crown, bridge and other fixed-restorative procedures where marginal detail is required.

This pack combines 300 ml base, 300 ml catalyst and two 50 ml Light Flow cartridges; confirm that this is the intended Variotime configuration.

* Material Type: Addition-cured silicone (VPS)
* System: Easy Putty with Light Flow wash material
* Easy Putty Pack: 300 ml base + 300 ml catalyst
* Light Flow Pack: 2 × 50 ml cartridges
* Viscosity: Putty and low-viscosity wash combination
* Application: Precision crown, bridge and prosthodontic impressions

1 Pack Contains:
* 1 × Easy Putty Base – 300 ml
* 1 × Easy Putty Catalyst – 300 ml
* 2 × Variotime Light Flow Cartridges – 50 ml each

1. Select a suitable impression tray and apply the recommended tray adhesive where required.
2. Measure equal portions of Easy Putty base and catalyst and mix until a uniform colour is obtained.
3. Load the mixed putty evenly into the prepared tray without trapping voids.
4. Attach a compatible mixing tip to the Light Flow cartridge and dispense around the prepared teeth and margins.
5. Seat the loaded tray promptly and hold it steadily without movement during setting.
6. Remove the impression carefully after complete setting and inspect margins and detail reproduction.
7. Rinse, disinfect and store the impression according to the applicable impression-material protocol.

Manufactured by: Kulzer GmbH, Germany

Not Applicable