• Angled cutting head at 45 degrees offers superior line-of-sight and access in hard-to-reach posterior areas.

• Ultra-sharp cutting edges engineered specifically for effortless trimming of soft ligature wires and elastic pins.

• Flush-cutting design minimizes sharp wire protrusion, significantly enhancing patient post-treatment comfort.

• High-grade surgical stainless steel construction prevents corrosion and withstands repeated sterilization cycles.

• Precision box joint alignment ensures consistent blade closure without binding or lateral wobble over time.

• Ergonomically contoured handles reduce operator hand fatigue during heavy clinical schedules.

• Non-glare finish provides optimal operational visibility under intense dental operating lamps.

The GDC Pin Ligature Cutter 45° (3000/111) is an essential orthodontic hand instrument specifically developed to trim soft wires and pin ligatures close to bracket surfaces. Featuring a 45-degree offset cutting head, this cutter grants clinicians excellent access and direct visibility in congested or hard-to-reach areas of the oral cavity, particularly around posterior teeth.

Crafted from premium surgical-grade stainless steel, the instrument retains tip sharpness through routine use and repeated steam sterilization. Its close-cutting action ensures clean wire termination without leaving sharp tail ends that could irritate oral mucosa, helping maintain patient comfort throughout active orthodontic therapy.

• Material: Surgical grade stainless steel with insert tips

• Working Tip Angle: 45 degrees

• Maximum Cutting Capacity: Soft wires and pin ligatures up to 0.015 inches (0.38 mm)

• Joint Mechanism: Box joint / Smooth hinge design

• Autoclavable: Yes (Steam sterilizable)

• Reusable: Yes

• Handle Surface: Smooth ergonomic grip

1 Pack Contains:

• 1 × GDC Pin Ligature Cutter 45° (Ref: 3000/111)

Thoroughly inspect the instrument for cleanliness and blade integrity prior to the procedure.

Select soft ligature wires or pin wires with a diameter not exceeding 0.015 inches (0.38 mm).

Position the 45-degree angled tip adjacent to the tie or archwire bracket interface.

Orient the flat side of the cutting head toward the soft tissue to ensure a close, flush cut.

Apply firm, steady pressure on the handles until the wire is completely severed.

Retrieve the cut wire fragment safely using a utility plier or suction.

Clean off organic debris immediately after use and follow standard sterilization protocols.

Manufacturer: GDC Fine Crafted Dental Pvt. Ltd.; Country of Origin: India

Not Applicable