• Eugenol-free – does not interfere with the polymerization of resin-based materials
• Short setting time for quick and efficient procedures
• Adjustable consistency to suit individual clinical needs
• Easy removal from crowns and cores after use
• Includes a special cleaner for convenient cleanup

Freegenol is an eugenol-free temporary luting cement designed for the cementation of indirect restorations.

It is fully compatible with acrylic resin materials, ensuring safe and effective use.

Freegenol is biocompatible with both tooth structure and soft tissues, offering a smooth, creamy consistency that is easy to mix and handle.Indications• Temporary cementation of crowns and bridges
Advantages• Eugenol-free formula – safe for use with resin materials
• Gentle on soft tissues – does not cause burning or irritation
• Compatible with plastics – will not damage acrylics
• Does not affect bonding – maintains the adhesion strength of bonded restorations
• Thixotropic properties – stays in place yet flows easily under pressure
• Quick and easy application – mixes in 20–30 seconds and sets hard within 3 minutes
• Simple cleanup after setting

COMPOSITION

Components%Zinc oxide70-75Vegetable Oil21-22Petrolatum3-5• Store at temperature of 4-25°C (39.2-77.0°F)
• Mixing time: 20-30 seconds
• Setting time: 3 minutes from the start of mixing
CONTRAINDICATIONS

In rare cases the product may cause sensitivity to some persons. If such reactions are experienced, discontinue the use of the product and refer to a physician.

CAUTIONS

In case of contact with eyes, flush immediately with water and seek medical attention.

• 1 x 20ml Base
• 1 x 20ml Accelerator

• Step 1: Dispense equal lengths of Base and Accelerator pastes onto the mixing pad.
• Step 2: Mix thoroughly for 20–30 seconds until a uniform consistency is achieved.
• Step 3: Apply the mixed paste into the temporary crown or bridge, then seat it onto the prepared dry tooth.
• Step 4: Allow to set for approximately 3 minutes from the start of mixing, then trim off any excess material.

Notes

• Adjusting setting time:
• Increase the Base for a faster set.
• Decrease the Base for a slower set.
• Maintain a Base : Accelerator ratio within 3 : 2 to 2 : 3.
• To prevent sticking:
• If the material adheres to tooth or metal surfaces, add Vaseline (up to 25% of the total mix).

• Warranty is not applicable for this product.