• Rapid setting formula shortens chairside waiting time during restorative procedures
• Soothing eugenol content helps minimize post-operative pulp irritation and discomfort
• Demonstrates smooth mixing consistency that allows precise, effortless placement
• Delivers strong marginal seal to protect against microleakage under temporary fills
• Formulated for easy removal from prepared cavities when placing permanent restorations
• Provides adequate compressive strength to endure normal masticatory forces during temporary phase

Dpi Kalsogen Powder & Liquid (FK005) is an established zinc oxide eugenol intermediate restorative cement designed for temporary filling and cavity lining duties in general dentistry. Formulated to offer accelerated setting behavior, this two-part system allows clinicians to complete provisional procedures efficiently without compromising seal integrity.

The eugenol ingredient provides an inherent obtundent effect on the dental pulp, making it a preferred choice for deep cavity preparations where pulpal sedation is desirable. The balanced powder-liquid ratio ensures a creamy, easily moldable paste that adapts securely to internal cavity walls while offering clean removal when transitioning to final restorations.

• Composition: Zinc oxide powder with optimized eugenol liquid base
• Product Form: Powder and liquid two-part system
• Curing Type: Chemical self-cure
• Setting Time: 4 to 6 minutes from initial mix
• Radiopacity: Radiopaque for straightforward diagnostic tracking
• Application: Temporary tooth restorations, intermediate base, and cavity lining
• Storage Conditions: Store tightly sealed in a cool, dry place away from direct light

1 Pack Contains:
• 1 × Powder Bottle – 30 g
• 1 × Liquid Bottle – 15 ml
• 1 × Measuring Spoon

1. Clean and thoroughly dry the prepared cavity area prior to application.
2. Dispense the recommended powder and liquid proportions onto a clean glass mixing slab.
3. Gradually incorporate the powder into the liquid using a stainless steel spatula until a homogeneous, putty-like consistency is achieved.
4. Apply the mixed cement into the prepared cavity using an appropriate dental instrument.
5. Adapt the material to the cavity margins and allow it to complete its self-cure cycle undisturbed.
6. Trim any excess cement and verify occlusal clearance once initial set is complete.

Manufactured by: Dental Products of India (DPI), India

Not Applicable