• A-silicone chemistry provides a dimensionally stable impression material platform
• Light Body consistency is suited to fine-detail wash application around preparations
• Putty Super Soft provides a high-viscosity tray material option
• Coordinated viscosities support common putty-wash impression techniques
• Elastic set material supports removal from undercut areas when used correctly
• Variant-based listing lets the clinic select the required President configuration

Coltene President Light Body and Kit belongs to the PRESIDENT A-silicone impression material system. The listing includes Light Body wash material and Putty Super Soft options so clinics can select the viscosity required for their impression technique. The low-viscosity material is intended for detailed wash application, while the putty option provides a high-viscosity tray material.

Use the correct variant, mixing accessories and tray technique for the planned case. Working and setting behavior can vary by formulation and temperature, so the current COLTENE instructions supplied with the selected pack should be used for exact timing, disinfection and storage requirements.

• Material: Addition-curing silicone / polyvinylsiloxane (PVS)
• Available variants: Light Body and Putty Super Soft
• Light Body form: Low-viscosity cartridge material
• Putty form: High-viscosity tray material
• Application: Precision dental impressions
• System use: Putty-wash or double-mix techniques as indicated

1 Pack Contains:
• Light Body variant: 2 × 50 ml cartridges with mixing tips
• Putty Super Soft variant: manufacturer-sealed base/catalyst putty pack
• Contents supplied depend on the selected subproduct

1. Select the Light Body or Putty Super Soft variant required for the planned impression technique.
2. Prepare the tray and oral field according to the clinical protocol and manufacturer instructions.
3. Dispense or mix the selected material using the correct cartridge, tip or dosing method.
4. Apply wash material around the preparation and load the tray material when using a combined technique.
5. Seat the tray without movement and maintain it until the material has fully set.
6. Remove, inspect and disinfect the impression according to the current instructions before laboratory transfer.

Manufactured by: Coltene Whaledent, Switzerland

N/A