* Ensures strong chemical adhesion between polyether materials and tray surfaces
* Reduces the risk of impression distortion caused by detachment during mouth removal
* Works effectively with both rigid plastic and metal impression trays
* Features a convenient brush-in-cap applicator for easy and uniform coverage
* Quick-drying formula minimizes patient chair time prior to material placement
* Provides thin, non-bulky film thickness to maintain anatomical accuracy
* Prevents debonding during sectioning and stone model pouring

3M ESPE Polyether Tray Adhesive is an essential accessory engineered to create a secure chemical bond between polyether impression materials and impression trays. Detachment of impression material from the tray during withdrawal from the oral cavity is a primary cause of marginal inaccuracies and dimensional distortions. This specialized adhesive prevents such failures by creating a reliable bridge across metal, plastic, and custom acrylic surfaces.

Supplied in a 17 ml glass bottle with an integrated brush cap, the liquid allows for smooth, even distribution without creating excess bulk. Once applied, the adhesive dries rapidly, requiring only a few minutes of air-drying before the polyether material is loaded. Utilizing this dedicated adhesive ensures consistent precision, accurate master casts, and reliable restorative outcomes.

* Product Form: Liquid adhesive
* Material Compatibility: Polyether impression materials
* Tray Compatibility: Metal, plastic, and custom resin trays
* Net Volume: 17 ml
* Application Type: Brush-on liquid
* Setting Time: Approx. 3–5 minutes air-dry time
* Shelf Life: 36 months from manufacture
* Storage Conditions: Store at room temperature away from direct flame

1 Pack Contains:
* 1 × Bottle – 17 ml

1. Clean and thoroughly dry the impression tray surface before adhesive application.
2. Apply a thin, uniform layer of adhesive over the entire tray area designated for impression material contact.
3. Allow the adhesive layer to air-dry completely for 3 to 5 minutes.
4. Load the polyether impression material into the tray immediately after drying.
5. Place the tray in the patient's mouth and carry out the impression procedure per clinical protocol.
6. Seal the adhesive bottle tightly right after use to prevent solvent evaporation.

Manufactured by: 3M Deutschland GmbH, Germany

Not Applicable